基于PLIF诊断技术的气膜冷却研究
Study on Film Cooling Based on PLIF Technology
DOI: 10.12677/MET.2016.51002, PDF,   
作者: 钟 策*, 吴伟亮：上海交通大学机械与动力工程学院，叶轮机械研究所，上海
关键词: 平面激光诱导荧光；气膜冷却；气膜完整性；Planar Laser-Induced Fluorescence； Film Cooling； Integrity of Cooling Film
摘要: 本文使用丙酮平面激光诱导荧光技术(Acetone-PLIF)，在掺混特性试验台上对冷却气膜与主气流的掺混进行了可视化测试。试验中采用的射流孔与实际叶片气膜孔处于同一尺度范围内。为研究气膜覆盖的完整性和贴壁性，定义了气膜的横截面长度和弯折角，并在三种吹风比下拍摄了掺混过程的荧光图像。通过图像处理，对上述参数进行了测量和分析，结论表明吹风比对气膜的有效覆盖长度和弯折角存在显著影响，在射流速度与主流相近时，气膜覆盖效果较好。通过图像，还捕捉到了射流孔附近的流动细节及变化规律。该技术在流体机械研究领域有广泛的应用前景。
Abstract: The film cooling visualization test is conducted on a mixed characteristic test bed using acetone PLIF method. The size of the jet hole in this experiment is in the same scale with the real one. In order to study the integrity and adherence of cooling film, the length and turning angle were de-fined and measured under 3 different conditions. The results showed that the blow rate has a sig-nificant influence on them. When the velocity of the jet and mainstream was close, the integrity of cooling film would be the best. The results also showed a lot of flow and mixing characteristics of film cooling. This technology has a bright future in study on fluid machinery.
文章引用：钟策, 吴伟亮. 基于PLIF诊断技术的气膜冷却研究[J]. 机械工程与技术, 2016, 5(1): 9-16. https://dx.doi.org/10.12677/MET.2016.51002

参考文献

[1] Blair, M.F. (1983) Influence of Free-Stream Turbulence on Turbulence Boundary Layer Heat Transfer and Mean Profile Development—1. Experimental Data. Journal of Heat Transfer, 105, 33-40. http://dx.doi.org/10.1115/1.3245555 [Google Scholar] [CrossRef] 
[2] Chernobrovkin, A., Lakshminarayana, B., Chernobrovkin, A., et al. (1998) Numerical Simulation and Aerothermal Physics of Leading Edge Film Cooling. ASME 1998 International Gas Turbine and Aeroengine Congress and Exhibition, American Society of Mechanical Engineers, New York, 103-118. http://dx.doi.org/10.1115/98-gt-504 [Google Scholar] [CrossRef] 
[3] Wright Lesley, M., McClain Stephen, T. and Clemenson Michael, D. (2010) Effect of Free Stream Turbulence Intensity on Film Cooling Jet Structure and Surface Effectiveness Using PIV and PSP. Journal of Turbomachinery, 133, 1703-1718.
[4] 李佳, 韩昌, 任静, 等. 基于压敏漆的带横槽气膜冷却实验与数值研究[J]. 工程热物理学报, 2010(2): 239-242.
[5] 赵建荣, 杨仕润, 俞刚, 张新宇. 火焰结构的平面激光诱导荧光技术观测[J]. 分析测试学报, 2003, 22(2): 16-18.
[6] 马骁, 何旭, 王建昕, 等. 用激光诱导荧光法测量GDI发动机缸内混合气分布[J]. 内燃机工程, 2010, 31(4): 1-5.
[7] 姚云, 郭方飞, 周波, 等. 喷射器内气-液两相流流型及其转换特性的研究[J]. 高校化学工程学报, 2009, 23(3): 392-396.
[8] Kumagai, T., Takeishi, K., Oda, Y., et al. (2008) Numerical and Experimental Research on a Mixing Process of Film Cooling Air with Mainstream (Thermal Engineering). Transactions of the Japan Society of Mechanical Engineers B, 74, 453-460.
[9] Lampard, D. and Hay, N. (2000) The Use of a Mass Transfer Technique to Infer Heat Transfer Coefficients on Film Cooled Turbine Components. Measurement Science & Technology, 11, 933-941. http://dx.doi.org/10.1088/0957-0233/11/7/309 [Google Scholar] [CrossRef] 
[10] 马骁, 何旭, 王建昕. 激光诱导荧光法用于内燃机燃烧可视化的研究进展[J]. 车用发动机, 2008(1): 7-13.
[11] Crimaldi, J.P. (2008) Planar Laser Induced Fluorescence in Aqueous Flows. Experiments in Fluids, 44, 851-863. http://dx.doi.org/10.1007/s00348-008-0496-2 [Google Scholar] [CrossRef] 
[12] 戴萍, 林枫. 燃气轮机叶片气膜冷却研究进展[J]. 热能动力工程, 2009, 24(1): 1-6.
[13] 吴介之, 马晖扬, 周明德. 涡动力学引论[M]. 北京: 高等教育出版社, 1993.
[14] Kelso, R., Lim, T. and Perry, A. (1996) An Experimental Study of Round Jets in Cross-Flow. Journal of Fluid Mechanics, 306, 111-144. http://dx.doi.org/10.1017/S0022112096001255 [Google Scholar] [CrossRef] 

为你推荐