变电站10 kV母线旁路转供带电作业研究与仿真
Research and Simulation of Live Operation of 10-kV Bus Bypass and Load Transfer in Substation
摘要: 为了研究变电站10 kV母线旁路转供带电作业过程，同时考虑母线旁路转供带电作业合环、解环前后时刻的暂稳态过程，本文首先提出基于叠加原理的单位电流法，实时计算合环操作过程中的循环电流；接着提出通过提高合环开关两侧母线负荷对称度以及减小合环开关两侧母线电压相量差来提高母线合环转供成功率，并运用MATLAB/Simulink仿真软件进行验证；最后采用电弧黑盒模型模拟电弧的暂态特性，并分别从分闸角、电缆导体截面积、电缆长度、合环开关两侧母线负荷对称度以及合环开关两侧母线电压相量差五个角度，研究合环开关解环过程对电弧电流的影响因素，并运用ATP-EMTP仿真软件进行分析研究。
Abstract: In order to research the live operation of 10-kV bus bypass and load transfer in substation and consider the transient steady state process before and after ring closing and ring unwinding, this paper first proposes a unit current method based on superposition principle to calculate the circulating current in the loop closing operation process in real time. Then, it is proposed to improve the success rate of bus turn-over by increasing the load symmetry of bus on both sides of the turn-over switch and reducing the voltage phase difference between bus on both sides of the turn-over switch and use MATLAB/Simulink simulation software to verify. Finally arc black box model are adopted to simulate the transient characteristics of arc, and respectively from five angles: the brake angle, cable conductor cross-sectional area, length of cable, closed loop switch on both sides of the bus load switch with symmetry and closed loop on both sides of the bus voltage phasor differential, the influence factors of the closed loop switch power network process on the arc current are analyzed, and ATP-EMTP simulation software is used for analysis.
文章引用：刘培贤, 杨洋, 龙楷, 丁超. 变电站10 kV母线旁路转供带电作业研究与仿真[J]. 智能电网, 2020, 10(5): 272-285. https://doi.org/10.12677/SG.2020.105030

参考文献

[1] 李红伟, 刘宇陆, 金勇, 等. 高压配电网负荷转供中的开关动作时序判定策略[J]. 电力系统自动化, 2018, 42(1): 82-90.
[2] 周晓宁, 徐伟, 胥传普, 等. 计及负荷转供措施的电网设备过载辅助决策[J]. 电力系统保护与控制, 2013, 41(23): 61-66.
[3] 章坚民, 相炜, 罗刚, 等. 配电网30˚相角差线路不停电转供的解决方案及关键分析[J]. 电力系统自动化, 2018, 42(1): 74-81.
[4] 祝旭焕, 童宁, 林湘宁, 等. 基于柔性多状态开关的主动配电网负荷在线紧急转供策略[J]. 电力系统自动化, 2019, 43(24): 87-101.
[5] 马静, 马伟, 王增平. 基于联络关系的主变故障负荷转供方案[J]. 电力系统保护与控制, 2014, 42(19): 1-7.
[6] 章立宗, 吴磊, 蒋玮, 等. 考虑二次转供的配电网负荷转供方案多目标优选技术[J]. 电网技术, 2019, 43(7): 2321-2328.
[7] 闫格, 吴细秀, 田芸, 等. 开关电弧放电电磁暂态干扰研究综述[J]. 高压电器, 2014, 50(2): 119-130.
[8] 林莘, 王亮, 徐建源, 等. 非平衡态双温度SF_6等离子体电弧数学模型研究[J]. 高压电器, 2015, 51(3): 1-7.
[9] 韩力, 周鑫, 李籽剑, 等. 基于Mayer电弧模型固相气流对电弧熄灭的有效性分析[J]. 电瓷避雷器, 2020(3): 74-80.
[10] 许晔, 郭谋发, 陈彬, 等. 配电网单相接地电弧建模及仿真分析研究[J]. 电力系统保护与控制, 2015, 43(7): 57-64.
[11] 王巨丰, 刘津濂, 刘其良, 等. 基于抑制建弧率的新型喷射气流灭弧防雷间隙机理研究[J]. 高电压技术, 2014, 40(9): 2862-2870.
[12] Wang, Z.X., Geng, Y.S. and Liu, Z.Y. (2012) Stepwise Behavior of Free Recovery Processes after Diffused Vacuum Arc Extinction. IEEE Transactions on Dielectrics and Electrical Insulation, 19, 582-590.
[Google Scholar] [CrossRef] 
[13] 罗益珍, 胡志坚, 雷文杰, 等. 带电分闸10 kV空载电缆电弧暂态过程研究[J]. 高压电器, 2018, 54(7): 172-178.

为你推荐