基于文丘里混合的多孔介质燃烧火焰数值模拟研究
Numerical Simulation Study of Incompletely Mixed Gas in Porous Media Combustion Flame Based on Venturi Mixture
DOI: 10.12677/MOS.2021.101005, PDF,    科研立项经费支持
作者: 郑 林, 徐洪涛：上海理工大学能源与动力工程学院，上海；廖晓炜*, 刘 峰：中国特种设备检测研究院，北京
关键词: 非均匀预混；多孔介质；燃烧稳定性；数值模拟；Incomplete Premixing； Porous Media； Combustion Temperature； Numerical Simulation
摘要: 燃料/空气文丘里混合器在工业预混燃烧领域应用广泛，混合气体的均匀性对燃烧性能影响较大。为研究非均匀混合气体在多孔介质内的燃烧特点，本文对甲烷/空气经文丘里混合后预混不均匀度(spatial mixing deficiency, SMD)约为2%的非均匀预混气体在双层多孔介质燃烧器内的燃烧火焰进行了模拟。研究结果表明：受混合不均匀的影响，非完全预混气体在多孔介质内点火燃烧时容易产生局部高温而降低燃烧器的使用寿命；而达到稳定燃烧时，预混不均匀使得燃烧火焰稳定性降低。
Abstract: The fuel/air Venturi mixer is widely used in the industrial premixed combustion. The uniformity of the mixed gas has a great influence on the combustion performance. In order to study the com-bustion characteristics of non-uniform mixed gas in porous media, this paper studied the me-thane/air non-uniform premixed gas after Venturi mixing and the Spatial Mixing Deficiency (SMD) is about 2%, when entering in the double-layer porous media burner. The research results show that: due to the influence of uneven mixing, non-premixed gas easily leads to local high tempera-ture when ignited and burned in the porous medium and reduces the service life of the burner. When stable combustion is achieved, due to the good thermal conductivity of porous medium, the local high temperature can be flattened, but flame stability becomes worse.
文章引用：郑林, 廖晓炜, 徐洪涛, 刘峰. 基于文丘里混合的多孔介质燃烧火焰数值模拟研究[J]. 建模与仿真, 2021, 10(1): 38-47. https://doi.org/10.12677/MOS.2021.101005

参考文献

[1] 程乐鸣, 岑可法, 周昊, 等. 多孔介质燃烧理论与技术[M]. 北京: 化学工业出版社, 2012.
[2] Filho, R.C.M. and Pimenta, A.P. (2011) A Two-Dimensional Numerical Simulation of Combustion and Heat Transfer in Radiant Porous Burners. Combustion Science & Technology, 183, 370-389. [Google Scholar] [CrossRef] 
[3] Shi, J.R., Yu, C.M., Li, B.W., et al. (2013) Experimental and Numerical Studies on the Flame Instabilities in Porous Media. Fuel, 106, 674-681. [Google Scholar] [CrossRef] 
[4] Hashemi, S.M. and Hashemi, S.A. (2017) Flame Stability Analysis of the Premixed Methane-Air Combustion in a Two-Layer Porous Media Burner by Numerical Simulation. Fuel, 202, 56-65. [Google Scholar] [CrossRef] 
[5] Liu, H., Dong, S., Li, B.W., et al. (2010) Parametric Investigations of Premixed Methane-Air Combustion in Two-Section Porous Media by Numerical Simulation. Fuel, 89, 1736-1742. [Google Scholar] [CrossRef] 
[6] Bubnovich, V., Henríquez, L. and Gnesdilov, N. (2007) Numerical Study of the Effect of the Diameter of Alumina Balls on Flame Stabilization in a Porous-Medium Burner. Numerical Heat Transfer, 52, 21. [Google Scholar] [CrossRef] 
[7] Nemoda, S., Trimis, D. and Živković, G. (2004) Numerical Sim-ulation of Porous Burners and Hole Plate Surface Burners. Thermal Science, 8, 3-17. [Google Scholar] [CrossRef] 
[8] Brenner, G., Pickenäcker, K, Pickenäcker, O., et al. (2000) Numerical and Experimental Investigation of Matrix-Stabilized Methane/Air Combustion in Porous Inert Media. Combustion and Flame, 123, 201-213. [Google Scholar] [CrossRef] 
[9] Barra, A.J., Diepvens, G., Ellzey, J.L., et al. (2003) Nu-merical Study of the Effects of Material Properties on Flame Stabilization in a Porous Burner. Combustion and Flame, 134, 369-379. [Google Scholar] [CrossRef] 
[10] 郑成航, 程乐鸣, 李涛, 等. 多孔介质燃烧火焰面特性数值模拟[J]. 中国电机工程学报, 2009, 29(5): 48-53.
[11] 邵卫卫, 赵岩, 刘艳, 等. 燃气轮机燃烧室预混燃烧器天然气燃料/空气掺混均匀性研究[J]. 中国电机工程学报, 2017(3): 148-156.
[12] 李宇红, 孙宝成, 祁海鹰. 燃烧室预混段燃料/空气混合规律的数值研究[J]. 热能动力工程, 2008, 23(3): 235-239.
[13] 谢刚, 李宇红, 祁海鹰. DLN燃烧室的燃料-空气预混均匀性研究[J]. 工程热物理学报, 2006, 27(z2): 227-230.
[14] 邓彩华, 童亮, 陈壁峰, 等. 多孔介质流动的直接数值模拟[J]. 武汉理工大学学报: 交通科学与工程版, 2011, 35(6): 1257-1260.

为你推荐