基于LabVIEW的固体氧化物燃料电池温度管理
Temperature Management of Solid Oxide Fuel Cells Based on LabVIEW
摘要: 快速启动是固体氧化物燃料电池的一个悬而未决的问题。为了快速启动，需要敏感的温度控制，固体氧化物电池温度控制体系是改善电池开发系统中温度控制的关键组成。针对快速预热启动固体氧化物燃料电池的问题，系统利用电加热的方式进行预热，上位机进行温度的监控和控制对固体氧化物燃料电池栈堆的温度管理。本系统主要采用LabVIEW软件和NI硬件对固体氧化物燃料电池的主要温度参数进行实时的监测，采用PID算法达成控制输出。本文对平板型的固体氧化物燃料电池加热设计及优化进行了归纳。
Abstract: Quick start is a pending problem for solid oxide fuel cells. For a fast start, sensitive temperature control is needed, and the solid oxide cell temperature control system is a key component of improving the temperature control in the battery development system. In view of the problem of rapid preheating and starting of the solid oxide fuel cell, the system uses electric heating for preheating, and the upper computer monitors the temperature and controls the temperature management of the solid oxide fuel cell stack. The system mainly uses LabVIEW software and NI hardware to monitor the main temperature parameters of solid oxide fuel cells in real time, and uses the PID algorithm to achieve the control output. The heating design and optimization of flat SOFC are summarized.
文章引用：刘雪姣, 孙磊, 蒋冬梅, 张军, 夏菽兰. 基于LabVIEW的固体氧化物燃料电池温度管理[J]. 软件工程与应用, 2022, 11(6): 1241-1247. https://doi.org/10.12677/SEA.2022.116126

参考文献

[1] 万兴文. 固体氧化物燃料电池预热过程温度梯度形成规律研究[D]: [硕士学位论文]. 徐州: 中国矿业大学, 2021.[CrossRef] 
[2] 王蔚国, 何长荣, 陈涛, 彭军, 翟惠娟, 覃朝晖, 马晓, 姜松林. 一种平板式固体氧化物燃料电池堆[P]. 中国, CN208444898U. 2019-01-29.
[3] 沈元兴. 固体氧化物燃料电池的研究[J]. 汽车实用技术, 2021, 46(7): 3-6. [Google Scholar] [CrossRef] 
[4] Malfuzi, A., Mehr, A.S., Rosen, M.A., Alharthi, M. and Kurilova, A.A. (2020) Economic Viability of Bitcoin Mining Using a Renewable-Based SOFC Power System to Supply the Electrical Power Demand. Energy, 203, Article ID: 117843. [Google Scholar] [CrossRef] 
[5] 常贵可, 张金磊, 郑春花, 张翼滉, 何成. 国内固体氧化物燃料电池研究现状与展望[J]. 广州化工, 2019, 47(17): 14-16.
[6] Zeng, Z.Z., Qian, Y.P., Zhang, Y.J., et al. (2020) A Review of Heat Transfer and Thermal Management Methods for Temperature Gradient Reduction in Solid Oxide Fuel Cell (SOFC) Stacks. Applied Energy, 280, Article ID: 115899. [Google Scholar] [CrossRef] 
[7] 卢静, 彭晖, 杨杰, 王俊. 基于LabVIEW的固体氧化物燃料电池监控系统开发[J]. 机床与液压, 2013, 41(10): 121-123+162.
[8] Ulf, B. (2015) Small Scale Power Generation for Road Trucks with Planar SOFC System. ECS Transactions, 68, Article No. 127. [Google Scholar] [CrossRef] 
[9] 袁建润. 基于LabVIEW的燃料电池硬件在环测试平台的研制[D]: [硕士学位论文]. 上海: 东华大学, 2014.
[10] 宋少辉. 固体氧化物燃料电池建模与控制策略研究[D]: [硕士学位论文]. 北京: 华北电力大学(北京), 2021. [Google Scholar] [CrossRef] 
[11] 裴锐, 陈政宇. NI-6002数据采集卡的调试与应用[J]. 仪器仪表用户, 2021, 28(12): 16-19.
[12] Huang, S.L., Yang, C., Chen, H., Zhou, N.N. and Tucker, D. (2022) Coupling Impacts of SOFC Operating Temperature and Fuel Utilization on System Net Efficiency in Natural Gas Hybrid SOFC/GT System. Case Studies in Thermal Engineering, 31, Article ID: 101868. [Google Scholar] [CrossRef] 
[13] Bossel, U. (2017) Innovative Temperature Management of SOFC Stacks. ECS Transactions, 78, Article No. 245. [Google Scholar] [CrossRef] 
[14] Mei, S.X., Lu, X.R., Zhu, Y. and Wang, S.X. (2021) Thermodynamic Assessment of a System Configuration Strategy for a Cogeneration System Combining SOFC, Thermoelectric Generator, and Absorption Heat Pump. Applied Energy, 302, Article ID: 117573. [Google Scholar] [CrossRef] 

为你推荐