位移相关磁流变脂减振器结构设计及优化
Structural Design and Optimization of Displacement-Dependent Magneto-Rheological Grease Damper
DOI: 10.12677/MOS.2023.123178, PDF,   
作者: 周豪亮：浙江理工大学机械工程学院，浙江 杭州；胡红生, 赵 伟：嘉兴学院信息科学与工程学院，浙江 嘉兴；欧阳青：嘉兴学院信息科学与工程学院，浙江 嘉兴；南京理工大学机械工程学院，江苏 南京；台州九桔科技有限公司，浙江 台州
关键词: 位移相关；磁流变脂；减振器；数学模型；优化设计；Displacement-Dependent； MR Grease； Damper； Mathematical Model； Optimized Design
摘要: 针对磁流变液减振器结构设计磁场利用率不高，同时磁流变液易产生沉降现象导致控制特性劣化，而磁流变脂粘度高、流动性差导致减振器初始阻尼力过大、阻尼调校空间小的问题，本文提出一种减振效果与活塞位移相关的新型磁流变脂减振器。本文阐述了该减振器的结构形式和工作原理，基于流体力学理论，选用宾汉本构模型，建立了输出阻尼力数学模型，在MATLAB环境下对模型进行仿真研究。为了提高减振器性能对其在基础尺寸上进行了合理的优化，优化结果显示优化后减振器相较之前得到了更低的初始阻尼力以及更宽的阻尼可调范围。
Abstract: Magneto-Rheological (MR) fluid dampers suffer from low magnetic field utilization rate, perfor-mance degradation resulting from MR fluid settlements, and poor fluidity and high viscosity of MR grease leading to excessive initial damping force of the damper. In order to overcome these disad-vantages, a new type of magneto-rheological grease (MRG) damper is proposed which related to the displacement of piston valve. And its structure and operation principle was illustrated, according to the theory of hydraulics, choose the Bingham model, and then the mathematical model of damping force is set up, MATLAB software was used to simulate the detailed mode. In order to improve the performance of the damper, the base dimensions were optimized, and the results showed that the optimized damper had a lower initial damping force and a wider adjustable damping range than before.
文章引用：周豪亮, 胡红生, 欧阳青, 赵伟. 位移相关磁流变脂减振器结构设计及优化[J]. 建模与仿真, 2023, 12(3): 1948-1957. https://doi.org/10.12677/MOS.2023.123178

参考文献

[1] 王昊, 胡海岩. 整车悬架的最优模糊半主动控制[J]. 振动工程学报, 2005, 18(4): 438-442.
[2] 林展, 覃海鹰, 王正峰. 直升机旋翼磁流变阻尼器样件仿真和试验验证[J]. 南京航空航天大学学报, 2021(2): 283-290.
[3] Yang, M.-G. and Cai, C. (2016) Longitudinal Vibration Control for a Suspension Bridge Subjected to Vehicle Braking Forces and Earthquake Excitations Based on Magnetorheological Dampers. Journal of Vibration and Control, 22, 3659-3678. [Google Scholar] [CrossRef] 
[4] Fu, Q., Wang, D.-H., Xu, L., et al. (2017) A Magnetorheological Damper-Based Prosthetic Knee (MRPK) and Sliding Mode Tracking Control Method for an MRPK-Based Lower Limb Pros-thesis. Smart Materials and Structures, 26, Article ID: 045030. [Google Scholar] [CrossRef] 
[5] Gomez-Ramirez, A., Lopez-Lopez, M.T., Gonzalez-Caballero, F., et al. (2011) Stability of Magnetorheological Fluids in Ionic Liquids. Smart Materials and Structures, 20, Article ID: 045001. [Google Scholar] [CrossRef] 
[6] Rankin, P.J., Horvath, A.T. and Klingenberg, D.J. (1999) Magne-torheology in Viscoplastic Media. Rheologica Acta, 38, 471-477. [Google Scholar] [CrossRef] 
[7] Ashtiani, M., Hashemabadi, S. and Ghaffari, A. (2015) A Review on the Magnetorheological Fluid Preparation and Stabilization. Journal of Magnetism and Magnetic Materials, 374, 716-730. [Google Scholar] [CrossRef] 
[8] Carlson, J.D. and Jolly, M.R. (2000) MR Fluid, Foam and Elastomer Devices. Mechatronics, 10, 555-569. [Google Scholar] [CrossRef] 
[9] Abdul Kadir, K.A., Nazmi, N., Mohamad, N., et al. (2022) Effect of Magnetorheological Grease’s Viscosity to the Torque Performance in Magnetorheological Brake. Materials, 15, 5717. [Google Scholar] [CrossRef] [PubMed]
[10] Ouyang, Q., Zheng, J., Li, Z., et al. (2016) Controllability Analysis and Testing of a Novel Magnetorheological Absorber for Field Gun Recoil Mitigation. Smart Materials and Structures, 25, Article ID: 115041. [Google Scholar] [CrossRef] 
[11] He, W., Ouyang, Q., Hu, H., et al. (2022) Semi-Active Control of Crankshaft Skyhook Based on Magnetorheological Torsional Damper. Frontiers in Materials, 9, Article ID: 933076. [Google Scholar] [CrossRef] 

为你推荐