标准铂电阻温度计自热效应的计算公式
Formula for Calculating the Self-Heating Effect of a Standard Platinum Resistance Thermometer
DOI: 10.12677/JSTA.2024.122017, PDF,   
作者: 任建平：山西省检验检测中心(山西省标准计量技术研究院)， 山西 太原
关键词: 计量学；标准铂电阻温度计；90国际温标；自热效应；焦耳热效应； Metrology； Standard Platinum Resistance Thermometer； ITS-90； Self-Heating Effect； Joule Heating Effect
摘要: 标准铂电阻的量值溯源中，自热效应是非常重要的一项指标。通常使用测温电桥先测量工作电流为1 mA下的温度计的电阻值，再调节电流为 mA并测量温度计的电阻值，计算前后两次电阻值的差，利用偏差函数计算的微分电阻比来换算成温度值。但是由于电阻的焦耳热效应，电流改变后，其电阻发生了变化(增加)，调节电流后的热效应功率并不是电流改变前的两倍，因此该计算方式具有一定的误差。在此基础上，笔者通过公式推导，提出新的计算公式。
Abstract: In the traceability of the magnitude of standard platinum resistance, the self-heating effect is a very important indicator. Generally, a temperature measuring bridge is used to measure the resistance value of the thermometer at 1 mA, then adjust the current to mA and measure the resistance value of the thermometer, calculate the difference between the two resistance values before and after, and convert it into the temperature value by using the differential resistance ratio calculated by the deviation function. However, due to the Joule heating effect of the resistor, the resistance of the resistor changes (increases) after the current changes, and the thermal effect power after adjusting the current is not twice as high as before the current changes, so this calculation method has a certain error. On this basis, the author proposes a new calculation formula through formula derivation.
文章引用：任建平. 标准铂电阻温度计自热效应的计算公式[J]. 传感器技术与应用, 2024, 12(2): 148-153. https://doi.org/10.12677/JSTA.2024.122017

参考文献

[1] 方院生, 王琦, 丁诚, 等. 标准铂电阻温度计的自热效应研究及零功率修正方法[J]. 测控技术, 2015, 34(1): 9-11.
[2] Preston-Thomas, H. (1990) The International Temperature Scale of 1990 (ITS-90). Metrologia, 27, 3-10. [Google Scholar] [CrossRef] 
[3] 王颖文, 张欣, 等. −38.8344~156.5985℃温区温标偏差方程外推和内插研究[J]. 计量学报, 2018, 37(6): 816-821.
[4] 高凯, 蒋庆, 等. 铂丝位错特性对标准铂电阻温度计稳定性影响的研究[J]. 计量学报, 2020, 41(11): 1352-1357.
[5] 邓小龙, 孙建平, 等. 退火对标准铂电阻温度计性能影响的研究[J]. 计量学报, 2015, 36(1): 26-30.
[6] Sun, J., Zhang, J.T. and Ping, Q. (2013) Improvements in the Realization of the ITS-90 over the Temperature Range from the Melting Point of Gallium to the Freezing Point of Sil-ver at NIM. International Temperature Symposium on Temperature-Its Measurement, 1552, 277-282. [Google Scholar] [CrossRef] 
[7] 李利峰, 李锐, 闫小克, 等. 镓熔点温坪复现研究[J]. 计量学报, 2020, 41(4): 419-424.
[8] 于帆, 孙建平, 等. 新制标准铂电阻温度计退火特性理论模型及验证[J]. 计量学报, 2021, 42(6): 759-764.
[9] 张洁天, 贾宏博, 等. 铂电阻温度传感器的自热效应[J]. 传感器技术, 2002, 21(12): 13-15.
[10] 任建平, 孙建平, 等. 标准铂电阻温度计自热效应对测量结果的影响[J]. 计量学报, 2021, 42(5): 589-594.
[11] Steur, P.P.M. and Dematteis, R. (2014) Water Triple-Point Comparisons: Plateau Averaging or Peak Value. International Journal of Thermophysics, 35, 620-627. [Google Scholar] [CrossRef] 
[12] Pearce, J.V., Rusby, R.L., Harris, P.M. and Wright, L. (2013) The Optimization of Self-Heating Corrections in Resistance Thermometry. Metrologia, 50, 345-353. [Google Scholar] [CrossRef] 
[13] 中国计量科学研究院. JJG 160-2007标准铂电阻温度计[S]. 北京: 中国计量出版社, 2007.

为你推荐